Front Barbell Squat To A Bench Exercise

Builds strength and control by improving stability, coordination, and efficient movement.

Front Barbell Squat To A Bench
Front Barbell Squat To A Bench
Level: expert
Equipment: barbell
Force: push
Mechanic: compound
Core muscles: quadriceps
Secondary muscle: calves, glutes, hamstrings

Description

Front barbell squat to a bench focuses on controlled movement and maintaining proper body alignment throughout the exercise. The goal is to create tension where needed while avoiding unnecessary strain or momentum. This helps improve movement quality, joint stability, and overall physical control.

Instructions:

  1. This exercise is best performed inside a squat rack for safety purposes. To begin, first set a flat bench behind you and set the bar on a rack that best matches your height. Once the correct height is chosen and the bar is loaded, bring your arms up under the bar while keeping the elbows high and the upper arm slightly above parallel to the floor. Rest the bar on top of the deltoids and cross your arms while grasping the bar for total control.
  2. Lift the bar off the rack by first pushing with your legs and at the same time straightening your torso.
  3. Step away from the rack and position your legs using a shoulder width medium stance with the toes slightly pointed out. Keep your head up at all times as looking down will get you off balance and also maintain a straight back. This will be your starting position. (Note: For the purposes of this discussion we will use the medium stance described above which targets overall development; however you can choose any of the three stances described in the foot positioning section).
  4. Begin to slowly lower the bar by bending the knees as you maintain a straight posture with the head up. Continue down until you touch the bench with your glutes. Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
  5. Begin to raise the bar as you exhale by pushing the floor mainly with the heel of your foot as you straighten the legs again and go back to the starting position.
  6. Repeat for the recommended amount of repetitions.

Exercise FAQ

What should I do if I feel it in the wrong place?

Check your setup, slow down, and reduce weight. If discomfort is sharp or in a joint, stop and choose an easier variation. Think of it as squat pattern done with repeatable, clean reps.

How can I make this exercise harder without adding a lot of weight?

Slow down the lowering phase, add a brief pause in the hardest position, or increase total reps while keeping form crisp.

Does grip or stance matter?

Yes—small changes can shift what you feel and how stable you are. Pick the most controlled position and keep it consistent while you learn the movement.

Disclaimer

This content is for educational purposes only and does not replace professional medical or fitness advice. Consult a qualified healthcare provider before beginning any new exercise routine. Exercise safely and listen to your body.

Alternative exercises:

Standing Hip Flexors

Standing Hip Flexors

Stand up straight with the spine vertical, the left foot slightly in front of the right. Bend both knees an...

Speed Squats

Speed Squats

This exercise is best performed inside a squat rack for safety purposes. To begin, first set the bar on a r...

Heaving Snatch Balance

Heaving Snatch Balance

This drill helps you learn the snatch. Begin by holding a light weight across the back of the shoulders. Yo...