Weighted Bench Dip Exercise
Builds strength and control by improving stability, coordination, and efficient movement.
Description
Weighted bench dip focuses on controlled movement and maintaining proper body alignment throughout the exercise. The goal is to create tension where needed while avoiding unnecessary strain or momentum. This helps improve movement quality, joint stability, and overall physical control.
Instructions:
- For this exercise you will need to place a bench behind your back and another one in front of you. With the benches perpendicular to your body, hold on to one bench on its edge with the hands close to your body, separated at shoulder width. Your arms should be fully extended.
- The legs will be extended forward on top of the other bench. Your legs should be parallel to the floor while your torso is to be perpendicular to the floor. Have your partner place the dumbbell on your lap. Note: This exercise is best performed with a partner as placing the weight on your lap can be challenging and cause injury without assistance. This will be your starting position.
- Slowly lower your body as you inhale by bending at the elbows until you lower yourself far enough to where there is an angle slightly smaller than 90 degrees between the upper arm and the forearm. Tip: Keep the elbows as close as possible throughout the movement. Forearms should always be pointing down.
- Using your triceps to bring your torso up again, lift yourself back to the starting position while exhaling.
- Repeat for the recommended amount of repetitions.
Exercise FAQ
What’s a common mistake people make here?
Rushing reps and losing body position. Keep the movement smooth and repeatable so tension stays where you want it. Think of it as pressing done with repeatable, clean reps.
How should I program this in a workout?
Use it after your warm-up when you’re fresh. Aim for 2–4 sets and choose a rep range that matches your goal (strength: lower reps; muscle: moderate reps). Think of it as pressing done with repeatable, clean reps.
Which muscles should feel like they’re doing most of the work?
You should feel the target muscles working while the rest of the body stays braced. If a joint or the lower back is doing the heavy lifting, reduce load and tighten your setup. Think of it as pressing done with repeatable, clean reps.
Disclaimer
This content is for educational purposes only and does not replace professional medical or fitness advice. Consult a qualified healthcare provider before beginning any new exercise routine. Exercise safely and listen to your body.
Alternative exercises:
Chain Handle Extension
You will need two cable handle attachments and a flat bench, as well as chains, for this exercise. Clip the...
Decline Dumbbell Triceps Extension
Secure your legs at the end of the decline bench and lie down with a dumbbell on each hand on top of your t...
Standing Bent-Over One-Arm Dumbbell Triceps Extension
With a dumbbell in one hand and the palm facing your torso, bend your knees slightly and bring your torso f...