Smith Single-Leg Split Squat Exercise
Builds strength and control by improving stability, coordination, and efficient movement.
Description
Smith single-leg split squat focuses on controlled movement and maintaining proper body alignment throughout the exercise. The goal is to create tension where needed while avoiding unnecessary strain or momentum. This helps improve movement quality, joint stability, and overall physical control.
Instructions:
- To begin, place a flat bench 2-3 feet behind the smith machine. Then, set the bar on the height that best matches your height. Once the correct height is chosen and the bar is loaded, step under the bar and place the back of your shoulders (slightly below the neck) across it.
- Hold on to the bar using both arms at each side (palms facing forward), unlock it and lift it off the rack by first pushing with your legs and at the same time straightening your torso.
- Position your legs by placing one foot slightly forward under the bar and extending your other leg back and place the top of your foot on the bench. This will be your starting position
- Begin to slowly lower the bar by bending the knee as you maintain a straight posture with the head up. Continue down until the angle between the upper leg and the calf becomes slightly less than 90-degrees (which is the point in which the upper legs are below parallel to the floor). Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knee should make an imaginary straight line with the toes that is perpendicular to the front. If your knee is past that imaginary line (if it is past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
- Begin to raise the bar as you exhale by pushing the floor with the heel of your foot mainly as you straighten your leg again and go back to the starting position.
- Repeat for the recommended amount of repetitions.
- Switch legs and repeat the movement.
Exercise FAQ
What should I focus on to keep good form?
Move with control and keep your torso stable. Use a range of motion you can own, and stop the set if you need momentum to finish reps. Think of it as squat pattern done with repeatable, clean reps.
How should I program this in a workout?
Use it after your warm-up when you’re fresh. Aim for 2–4 sets and choose a rep range that matches your goal (strength: lower reps; muscle: moderate reps).
How can I make this exercise harder without adding a lot of weight?
Slow down the lowering phase, add a brief pause in the hardest position, or increase total reps while keeping form crisp. Think of it as squat pattern done with repeatable, clean reps.
Disclaimer
This content is for educational purposes only and does not replace professional medical or fitness advice. Consult a qualified healthcare provider before beginning any new exercise routine. Exercise safely and listen to your body.
Alternative exercises:
Step Mill
To begin, step onto the stepmill and select the desired option from the menu. You can choose a manual setti...
Dumbbell Squat To A Bench
Stand up straight with a flat bench behind you while holding a dumbbell on each hand (palms facing the side...
Bicycling
To begin, seat yourself on the bike and adjust the seat to your height.